Taiwan

Type A

Type B

Regulatory agency

• Bureau of Standards, Metrology and Inspection (BSMI), Ministry of Economic Affairs (MOEA)

Regulations

• The BSMI Safety Mark is mandatory for electrical and electronic products under the Commodity Inspection Act.
• There are 4 inspection schemes which require compliance with product inspection requirements:
  • Type approval batch inspection (TABI)
  • Monitoring inspection (MI)
  • Registration of product certification (RPC)*
  • DoC
• The choice of the appropriate conformity assessment procedure depends on the product characteristics as well as other factors.
• Compliance with Chinese National Standards (CNS).
• Testing should be done by BSMI or designated test laboratories.

• EMC compliance is required for the above, where applicable.

* The RPC scheme is broken down into 7 modules of assessment and requires manufacturers to comply with any one or a combination of these modules. 3C secondary lithium cells/batteries and power banks are mandatory to be included under the RPC scheme from 1 May 2014.

Guidelines

• Applicants must be a registered company in Taiwan.

GENERAL GUIDE

• TABI – Application with documentation and test reports are submitted to BSMI.
• MI – A simplified batch-by-batch inspection system.
• RPC – Application with documentation and test reports are submitted to a designated Certification Body (CB).
• DoC – Application with DoC are submitted to BSMI; applicant maintains technical file.

Applicable product categories

• Audio/video products
• Home appliances
• Information Technology Equipment
• Laser pointers
• Power tools, etc.

To determine if a particular product is subject to the above regulations, please contact us.

Our services at a glance

• TÜV SÜD is a designated CB able to perform testing and issue Certification of Conformity (CoC) for a wide scope, supporting manufacturers in the applicable BSMI conformity assessment procedures.
  
   

Regulatory agency

Bureau of Energy (BOE), Ministry of Economic Affairs (MOEA)

Regulations

• Minimum Energy Performance Standards (MEPS) and Energy Efficiency Rating Labelling are required for many products.
• Product energy efficiency ratings are determined based on the energy efficiency distribution of commercially available products, in coordination with the formulation/revision of MEPS.
• Voluntary government-backed labelling through Energy Conservation Label.

Guidelines

• After passing testing for compliance with certain standards, applicants may attach Energy Labels to products.

Applicable product categories

• A full list of product categories may be found here. To determine if a particular product is subject to the above regulations, please contact us.

Our services at a glance

TÜV SÜD has the experience and capability to support manufacturers in attaining compliance with Taiwanese requirements and obtaining the necessary approval. TÜV SÜD can also support manufacturers in obtaining voluntary endorsement labels.

Regulatory agency

• National Communications Commission (NCC)

Regulations

• A type approval scheme is to be followed.
• The NCC Certification Mark should be affixed on the product after approval is granted.
• Testing must be conducted by a NCC-approved test laboratory.
• Type approval certificate is issued by a NCC-approved CB.
• EMC compliance is required for the above, where applicable.
• From 6 September 2017, those who sell approved Compliance Approval Regulations on Controlled Telecommunications Radio-Frequency Devices (CTRFD) on the internet shall provide approval or a Declaration of Conformity (DoC) label on the webpage.

Guidelines

• A local representative is required.
• Most NCC-approved test laboratories are in-country, thus, test reports generated by foreign test laboratories will not be accepted unless there are recognition agreements in place.

Applicable product categories

• To determine if a particular product is subject to the above regulations, please contact us.

Our services at a glance

• As a NCC-approved test laboratory, TÜV SÜD is able to perform the required testing to compliance and support manufacturers in obtaining the NCC certification mark.